"S" Lock


Quick adjust swivel lock for Harris "S" style bipods



   


Installation Instructions:

Remove the nut "A" in the front of the bipod using a 1/4" socket tool.

Unscrew the knurled nut "B" with your fingers.

 

     
             
    Picture shows both nuts "A" and "B" removed from the assembly.      
             
    In the back of the Bipod you will find the retaining pin "C" hold it in position with your finger      
 
   

Install the spacer "D" making sure the beveled side faces away from the bipod.

Screw the lever "E" turning clockwise until is firm against the spacer "D" At this point you can let go of the retaining pin "C" make sure it is seated properly.

     
 
 

Tighten the lever "E" untill it locks the swivel action of the bipod. Do not overtighten, doing so may strip the threads on the bipod rod.

The lever "E" is spring loaded and it will engage/disengage the swivel mechanism when pulled away from bipod assembly allowing to losen or tighten the swivel.

     
 

• Go back to Harris Bipods Home Page

 

Phone (203) 266-6906

Copyright © 2013, All Rights Reserved