- For American Size Rails
- 5/16″ across rail slot
- Slides into 5/16" rails and locks into place with a set screw
- Made in the USA
-
-
- Rubber spacer may allow mounting on thin fore-ends and Schnable type fore-ends
- Reversable to change angle of bipod
- Made in the USA
-
- For European size rails
- 3/8 inch across rail slots
- Slides into 3/8" rails and locks in place with a set screw
- Made in the USA
-
- Fits AR-15/M16 standard handguards without alteration
- Made to fit AR-15 round handguard
- Will not fit the older triangular type hand guard
- Package contains a perforated flange with a threaded shank, a rectangular washer, a Q.D. stud and a sling swivel
- Made in the USA
-
- Universal barrel adapter – Attaches to barrel not stock
- Fits barrels from .550 inch diameter to .812
- Requires 2 inches of uncluttered barrel for mounting
- Requires 6 inch or longer barrel
- Hinged mounting bracket allows bipod legs to fold backward
- Best application is on single shot pistols
- Not recommended for shoulder guns
- Mounting bipod on rifle barrels may affect accuracy
- Weight: 3 ounces
- Made in the USA
-
- Fits Remington Semi-automatic rifles, Models No. 4, 74 and 7400
- The adapter consists of two-parts, the base and the fore-end screw
- Made in the USA
-
- Has radiused flange for mounting to wood or polymer fore-ends under gas tubes
- Flange has a ¾ Inch radius
- Made in the USA
-
- 5/8-inch round head flange nut
- Works well Ruger Model 77 Synthetic stocks
- Made in the USA
-
- Allows mounting of stud on hollow plastic fore-ends
- Flange is 5/8 inch wide by 1 3/8 inch long.
- The shank is 5/16-inch diameter with 10-32 threaded hole.
- Stud and washer provided
- The purpose of the big-headed flange nut is to provide more support for the sling stud on thin walled fore-ends
- Made in the USA
-
Features:- For M1A and M16 rifles with both wood and polymer stocks
- Stud 3/8” / Thread 10/32
- Made in the USA by MIM Mfg.
- Lifetime Guaranteed
-
- For flat bottom stocks
- Adapter holds bipod in proper alignment
- Fits bench rest type fore-ends from 2” to 4” in width
- Stud is required on fore-end
- Made in the USA
-
